Airtable and todoist integrations6/17/2023 ![]() ![]() The airtable source connector supports the following sync modes: Feature Similarly, if you delete a table that was previously syncing, the connector will stop syncing it. This is because there is no way for Airtable to tell Airbyte which tables have been renamed. At that point, the table will begin syncing to a table with the new name in the destination. Please keep in mind that if you start syncing a table via Airbyte, then rename it in your Airtable account, the connector will not continue syncing that table until you reset your connection schema and select it again. Note on changed table names and deleted tables Select Personal Access Token from the Authentication dropdown and enter the Access Token for your Airtable account.On the Set up the source page, enter the name for the Airtable connector and select Airtable from the Source type dropdown.In the top-right corner, click +new source. In the left navigation bar, click Sources.Navigate to the Airbyte Open Source dashboard.We are working on a permanent fix that you can follow here. You can re-authenticate your Airtable connector to solve the issue temporarily. When using OAuth, you may see a 400 or 401 error causing a failed sync. To authenticate using a Personal Access Token, select Personal Access Token from the Authentication dropdown and enter the Access Token for your Airtable account.To authenticate using OAuth, select OAuth2.0 from the Authentication dropdown click Authenticate your Airtable account to sign in with Airtable, select required workspaces you want to sync and authorize your account. ![]() We recommend using OAuth for Airbyte Cloud. You can use OAuth or a Personal Access Token to authenticate your Airtable account. On the Set up the source page, enter the name for the Airtable connector and select Airtable from the Source type dropdown. In the left navigation bar, click Sources. Setup guide Step 1: Set up Airtable For Airbyte Cloud: Personal Access Token with the following scopes:.Enterprise level accounts are not supported yet. Currently, this source connector works with Standard subscription plan only. ![]()
0 Comments
Leave a Reply. |